Drucker Diagnostics Model 755 Centrifuge - Manual (Page 13)

13
D. C.
B.
C.
D.
A.
BLUE GREEN
75mm Tube
Holder*
with 1525
cushion*
GREEN RED
75mm
Tube
Holder*
100mm
Tube
Holder
with
1525
cushion*
B.
BLACK RED
A.
BLACK
125mm
Tube Holder*
125mm Tube
Holder* with
1525 cushion*
100mm
Tube Holder
or
* This part is available as an accessory. Contact The Drucker Company for assistance.
Tube Holder Configurations: 12-Place or Fixed Angle only
Your Horizon Model 755 centrifuge can spin various test tube sizes ranging from
1.5mL to 15mL, (up to 125mm, (4.9 in.) in length), with the appropriate acces-
sories. Use the following chart and drawing to determine which tube holder and
cushion combination should be used with your application.
DIRECTIONS:
1. Compare the tube to be spun with the four boxes shown below.
2. Find the box that most closely matches the tube’s length. NOTE: The tube
length with its stopper or cap must be shorter then the chosen box or the tube
will not fit properly in the tube holder.
3. Match the letter from the chosen box with one of the configurations shown.
For Example: A tube is found to be as long as box B. Accordingly,
we can use a 125 mm tube holder with a 1525 cushion or a 100mm
tube holder with no cushion, (configuration B).