Drucker Diagnostics Model 755 Centrifuge - Manual (Page 8)

8
Lid Safety
Switch
‘RUN’
Indicator
‘UNLOCKED’
Indicator
‘START’
Button
‘LATCH’
Indicator
‘OPEN/
EMERGENCY
STOP’
Button
Cycle
Counter
Power
(On/Off)
Button
Speed
Control
(755V Only)
Lights up when the
machine is in operation,
(power is being applied
to the motor).
Lights up when the lid
has been closed and
latched properly.
Lights up to indicate that
the locking mechanism
has been deactivated,
allowing access to the
rotor chamber.
This button controls the
power to the centrifuge.
The power is on when
the button is illuminated.
Use this input to set the
running speed of the
centrifuge. The speed
may also be adjusted
while the centrifuge is
running.
Begins a new run, (the lid
must be closed, see pg. 6).
Allows access into the
rotor chamber by
disengaging the locking
mechanism. Entry is only
permitted when the rotor is
stopped. Pressing this
button during operation will
terminate the run and
unlock the lid after the
rotor has come to a stop.
This counter increments
once for each run of the
centrifuge. This count is
used for both warranty
purposes and for routine
maintenance.
The lid safety switch
prevents the centrifuge
from operating while the lid
is open. If the knob is not
turned completely
clockwise to its stop
position the centrifuge
cannot operate.
Programming functions are
accessed by first opening
the lid safety switch.
‘RUN’
Indicator
‘LATCH’
Indicator
‘UNLOCKED’
Indicator
Power
(On/Off)
Button
Speed
Control
(755V
ONLY)
‘START’
Button
‘OPEN /
EMERGENCY
STOP’
Button
Cycle
Counter
Lid
Safety
Switch
Control Panel: