Edge Lighting Box Pro Aim MR16 User Manual
Page 2
Advertising
F
7:
body and push it completely until it snaps in place properly.
Line up the notch on the shade with the tabs on the fixture
C
3: ighten the M4 set screw on the front of the shade with the
2mm Allen driver provided.
T
SHADE
2MM ALLEN
DRIVER
M4 SET SCREW
D
4:
pen point to loosen and remove the lens holder ring.
From the inside of the shade, use a small Allen wrench or a
4
SMALL ALLEN
WRENCH
E
5:
louver into the shade.
6: Replace and tighten the lens holder ring to secure the lenses
in place.
Place the lens(es), or a combination of a lens and hexcell
SHADE
LENS
LENS
LENS HOLDER RING
5
6
2
SHADE
NOTCH
FIXTURE
BODY TAB
7
3
LENS HOLDER RING
SHADE
4
Advertising