Edge Lighting Cirrus Float for Monorail - Manual (Page 2)

6: Feed the inner coaxial cable along with strain relief tube
into the coaxial fixture connector.
D
6
STRAIN RELIEF TUBE
INNER WIRE
FIXTURE
CONNECTOR
9: Make sure the strain relief tube is completely into the
coaxial fixture connector and the slot on the strain relief
tube is not inline with the M4 set screw.
10: Tighten the M4 set screw with the 2mm Allen wrench
F
9
10
2MM ALLEN WRENCH
M4 SET SCREW
STRAIN RELIEF TUBE
COAXIAL FIXTURE
CONNECTOR
E
1.5MM ALLEN WRENCH
M3 SET SCREW
OUTER METAL JACK INNER WIRE
8
7
7: Keep feeding the coaxial cable in until the inner wire is
visible in the screw hole of the fixture connector tip.
8: Hold the fixture connector and coaxial cable in place.
Replace and tighten the M3 set screw on fixture connector
tip with the 1.5mm Allen wrench.
Install Cirrus Float to Two Port Fast Jack 26" Rectangle
Canopy (FJP-26RE-XX)
M3 SET SCREW
1.5MM ALLEN
WRENCH
ADJUSTABLE
CONNECTOR
1
1
NOTE:
Fast Jack ports will be used as a support post and the other
will power the fixture. The center distance between the Fast
Jack ports is 14". Depending on the fixture length, the coaxial
and aircraft cable posts on the fixture will need to be moved
towards the center so that they are 14" apart. Make sure the Fast Jack Canopy is installed. One of the
G
1: Loosen the M3 set screw on the adjustable post with the
1.5mm Allen wrench to remove the adjustable connector
from the Monorail connector.
MONORAIL
CONNECTOR
2