Install cirrus float to monorail 2 circuit, Circuit #1 circuit #2 – Edge Lighting Cirrus Float for Monorail User Manual

Page 6

Advertising
background image

Install Cirrus Float to Monorail 2 Circuit

NOTE: To install the aircraft cable side of the fixture onto the
ceiling, follow steps 3 through 11 and 13 in the “Install Cirrus
Float to Single or Multi Port Fast Jack Canopies” starting on
page 4.

1: Place the Fast Jack housing onto the Monorail 2 Circuit and
use fingers to tighten the Fast Jack housing connector to the
Fast Jack housing. Make sure the Fast Jack housing
connector is not cross-threaded.

2: Place the Fast Jack housing connector of the adjustable
connector onto the Monorai 2 Circuitl and finger-tighten the
adjustable connector to the Fast Jack housing. Make sure
the Fast Jack housing connector is not cross-threaded.

3: Push the tab on the adjustable connector and feed the
aircraft cable through the tab.

4: Pull the aircraft cable coming out of the side of the
adjustable connector. Release the tab to lock the aircraft
cable in place.

5: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack housing connector making sure that it is not
cross-threaded.

6: Readjust the aircraft cable to the desired height using steps
3 and 4. When desired height is achieved, release the tab
to lock the aircraft cable in place.

7: Trim off excess aircraft cable coming out of the adjustable
connector side hole for a neat finished look.

8: To power the fixture from circuit #1, top and bottom
(neutral) rails, tighten the M3 set screw on top of the
housing with the 1.5mm Allen wrench. Make sure this set
screw connection is very tight.

9: To power the fixture from circuit #2, middle and bottom
(neutral) rails, remove the M3 set screw from top of the
housing and tighten it into the side threaded hole with the
1.5mm Allen wrench. Make sure this set screw
connection is very tight.

NOTE:

set screw to select a circuit on the Monorail 2 Circuit connector.

To avoid shorting the system, do not use more than one

NOTE:

Do not load either circuit over the maximum system

rating.

X

8

9

CIRCUIT #1

CIRCUIT #2

1
2

N

1
2

N

M3 SET
SCREW

1.5MM ALLEN
WRENCH

6

2

ADJUSTABLE
CONNECTOR

FAST JACK
HOUSING

FAST JACK
HOUSING

V

FAST JACK

HOUSING

CONNECTOR

FAST JACK
HOUSING

5

W

3

TAB

SIDE HOLE

AIRCRAFT
CABLE

4

FAST JACK
HOUSING

Advertising
This manual is related to the following products: