Edge Lighting 20" Fast Jack Canopies - Manual

SAVE THESE INSTRUCTIONS!
FJP-16RD-_-20W-_
- This product is dimmable with a low voltage electronic
dimmer.
- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.
Installation Instructions for 5,7, & 9 Port Round Fast Jack Canopies
904-FJP-16RD-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2012 Edge Lighting. All Rights Reserved.
Install the Canopy
A
1: Loosen and remove the six #8-32 screws around the canopy
to remove the mounting plate.
Install the Canopy
#8-32 SCREW
1
1
MOUNTING PLATE
CANOPY
2:
Align the mounting plate slots with the electrical box holes
and secure it to the electrical box holes with the provided
two #8-32 screws.
Feed the power wires through mounting plate center hole.
3:
4: Mark the three mounting plate holes on the ceiling.
5: Tap the anchors through the mounting plate holes onto the
marked point up to the threaded portion with a hammer.
6: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
B
MOUNTING PLATE
#8-32 SCREW
3
2
3
C
MOUNTING PLATE
4
D
MOUNTING PLATE
ANCHOR
6
6
5
1