Edge Lighting 300W/12V Electronic Remote Transformer - Manual (Page 2)

2
Install the Remote Transformer
1:
the transformer to remove the transformer cover. Loosen and remove the two Phillips screws on the sides of
A
NOTE: In order to use small gauge wires from the transformer
to the electrical box, it is recommended to install the remote
transformers as near as possible to the electrical box. See "Low
Voltage Wire Size Chart" on page 3.
TRANSFORMER COVER
2: Secure the transformer housing in place (hardware not
included).
3: Install a conduit and power wires from the panel to the
transformer.
4: DO NOT connect the power wires to the panel at this time.
5: Ground the transformer housing in accordance with local
electrical codes.
6: Connect the 120V black transformer wire to the hot power
with a wire nut.
7: Connect the 120V white transformer wire to the neutral
power with a wire nut.
PHILLIPS SCREW
B
1
1
3
CONDUIT
6
7
TRANSFORMER
HOUSING