Edge Lighting 300W/12V Electronic Remote Transformer User Manual
Page 4
Advertising
4
D
12: Connect the 120 volt power line wires at the panel.
13: After operating the system for a few minutes, on the low
voltage side, all electrical connection points should be no
more than warm to the touch. If a connection is hot to the
touch, retighten the connection and check to ensure that
the temperature decreases.
14: Replace the transformer cover and tighten the two Phillips
screws on the sides of the transformer.
PHILLIPS SCREWS
TRANSFORMER COVER
14
14
Advertising
See also other documents in the category Edge Lighting Lighting:
- Chopper (2 pages)
- Form Round & Square MR16 (2 pages)
- Form Round & Square 2-Head MR16 (2 pages)
- Function Round & Square MR16 (2 pages)
- Harley (2 pages)
- Harley with Gobo (4 pages)
- Low Rider (3 pages)
- Low Rider Spinner (2 pages)
- Rebel (2 pages)
- Spirit (3 pages)
- Triumph (3 pages)
- Vespa (1 page)
- S1 - S3 Shade Accessories (2 pages)
- S5 - S7 Shade Accessories (1 page)
- Adam Pro Aim MR16 (4 pages)
- Box Pro Aim MR16 (4 pages)
- Neo Pro Aim MR16 (4 pages)
- Phi Pro Aim MR16 (4 pages)
- Alps (4 pages)
- Bloom (3 pages)
- Bubble Ball (4 pages)
- Crossroads (3 pages)
- Crystal Galaxy (4 pages)
- Crystal Galaxy with Downlight (5 pages)
- Crystal Spirit (4 pages)
- Drop 2 Pendant (2 pages)
- Everest (3 pages)
- Ice (3 pages)
- Izar (4 pages)
- Jelly (2 pages)
- K2 LED (2 pages)
- King's Crossing (4 pages)
- LED Pipe (2 pages)
- M&M LED (2 pages)
- Mata Hari 3 (3 pages)
- Outlaw (4 pages)
- Quattro LED (2 pages)
- Scope LED Pendant (3 pages)
- Tower of Crystal Love (4 pages)
- Tower of Love Shattered (4 pages)
- Vase (2 pages)
- Vessel 4 (3 pages)
- Vessel 6 (2 pages)
- White Night & Dark Night (3 pages)
- Zzz Lamp (4 pages)