Edge Lighting Twiggy Hinged, Direct 1" Lens User Manual
Installation instructions for, Important information, Save these instructions
Installation Instructions for
Twiggy Hinged 12V AC, Direct Lens with 4"
Square Canopy or 1" Rectangular Canopy
904-TWH12-D1-01
- This instruction shows a typical installation.
- This product must be installed by a qualified electrician.
- The 1RE version mounts to the provided C-1RE-JBOX. The
4SQ version mounts to standard electrical box with plaster
ring or octagon box.
- Before beginning any electrical work, ensure that
the power to the installation is turned OFF!
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2014 Edge Lighting. All Rights Reserved.
1
A
2
3
1
2
3
1
Section One: Steps for TWH12-D1-1RE
1: Mount each adjustable mounting bar to one side of the junction box (mounts to any side of the housing depending on the
orientation of the channel) and secure them with the mounting brackets and two Phillips screws provided.
2:
box to be mounted.
3: Place the adjustable mounting bars between the studs.
4: Make sure the lips on the adjustable mounting bars are
against the studs. Secure the adjustable bars to the studs
with the eight #8 screws.
Select the location between the two studs for the junction
NOTE:
The adjustable mounting bars mount to studs that are
spaced 13" to 24" apart.
2
3
1
2
3
1
JUNCTION
BOX
MOUNTING
BRACKET
ADJUSTABLE
MOUNTING BAR
PHILLIPS
SCREW
1
1
JUNCTION
BOX
2
3
1
2
3
1
B
JUNCTION
BOX
ADJUSTABLE
MOUNTING BAR
STUD
#8 SCREW
3
4
2
2
3
1
2
3
1
SAVE THESE INSTRUCTIONS!
5: Remove a knockout to install the power line conduit.
6: Ensuring power to the junction box is off, install the conduit
and run the 120V power wires.
C
JUNCTION
BOX
STUD
5
CONDUIT
6
VERTICAL
ORIENTATION
HORIZONTAL
ORIENTATION
TWH12-D1-4SQ-_
TWH12-D1-1RE-_
NOTE:
The adjustable mounting bars mount to studs that are spaced 13" to 24" apart.
NOTE:
Ensure the opening of the junction box is alinged with the center of the desired fixture location. If necessary, adjust the junction box
location by loosening the screws and sliding the junction box to the proper location. Tighten the Phillips screws after adjusting.