Edge Lighting Twiggy Hinged, Direct 1" Lens User Manual
Page 3
2
E
WALL
BACK COVER
0.05 ALLEN
WRENCH
CHANNEL
#4-40
SET SCREW
5: Line up the hinge to the anchors and secure it by tightening
the #8 screws to each hinge.
2: Unfold the channel hinges. Align the channel between the
marked lines and mark the hinge holes 3/16" away from the
center line.
HINGE
BACK OF CHANNEL
MOUNTING
HOLE
G
WALL
CHANNEL
HINGE
CENTER LINE
HINGE LINE (3/16" AWAY
FROM THE CENTER LINE)
2
2
3: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
4: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
ANCHOR
ANCHOR MUST
BE FLUSH TO WALL
H
CEILING
3
4
NOTE:
loosen the #4-40 set screw with the 0.05 Allen wrench on one of the
back cover moving the opening hole to one end. Pull the wire out of
that end & retighten the #4-40 set screw with the 0.05 Allen wrench.
If the junction box is located at one end of the channel, then
5
HINGE
J
WALL
CHANNEL
HINGE
5
5
#8 SCREW