Edge Lighting Light Channel Trim 1.6 - Manual (Page 3)

3
17: Push the male connector of the Soft Strip into the female connector of the power connector.
18: Carefully remove the backing from the LED soft strip, make sure not to remove the tape from the soft strip. Firmly press down
the adhesive portion of the soft strip onto the channel surface while removing the rest of the backing, making sure there are
no air bubbles that can cause surface irregularities. Ensure the entire length of the channel is covered with Soft Strip to avoid
unlit areas.
CHANNEL
SOFT STRIP
PAPER
BACKING
POWER
CONNECTOR
G
17
18
CHANNEL
CHANNEL
LENS
LENS
LENS FULLY
SEATED
LENS NOT
FULLY SEATED
21: Snap the lens into the channel and make sure it is fully
seated along the length of the channel opening.
H OPTIONAL:
19: Trim excess LED strip at cut point.
20: If channel length has been modified as per the “Section
Three: Modifying Channel Length” section on Page 4,
insert excess LED strip into slot cut between the channel
and end cap.
19
20
LED STRIP
END CAP
CHANNEL
LED STRIP
I