Edge Lighting Light Channel Trim 1.6 User Manual
Page 4
1: Mark the wall where channel mounting holes are located along the channel opening.
2: Cut 1" thick by 3" long sections of 2x4 to use as support bars.
3: Place the cut support bars through and behind the drywall at the marked mounting hole location.
4: Secure the support bars through drywall using two #6 drywall screws. Continue the installation as per Section One, Step 8.
1
1
3
3
Section Two: Alternate Installation w/Uneven Studs
Section Three: Modifying Channel Length
1
length, remove one channel end cap by loosening two #4-40
screws with the provided Torx drive.
2: Cut channel to desired length.
3: Slightly grind off (~1/16") of the bottom of the channel. This
will allow excess LED strip to pass through after the end cap
is reinstalled.
4: Reinstall the channel end cap by replacing and tightening the
two #4-40 screws with the provided Torx drive.
: If desired fixture length is less than the provided channel
L
1
2
3
4
END CAP
CHANNEL
#4-40
SCREWS
CHANNEL
END CAP
#4-40
SCREWS
J
K
4
4
4