Latch child restraint fixing system – BMW ActiveHybrid 750Li 2011 User Manual
Page 63
completely. Do not
change the backrest width again and do not call
up a memory position.
Backrest width for the child seat
Before installing a child restraint fixing
system in the front passenger seat, the backrest
width must be opened completely. Do not
change the adjustment after this; otherwise, the
stability of the child seat will be reduced.◀
Child seat security
The rear safety belts and the front passenger
safety belt can be locked against pulling out for
mounting the child restraint fixing systems.
Locking the safety belt
1.
Pull out the belt webbing completely.
2.
Secure the child restraint fixing system with
the belt.
3.
Allow the belt webbing to be pulled in and
pull it taut against the child restraint fixing
system. The safety belt is locked.
Unlocking the safety belt
1.
Unbuckle the belt buckle.
2.
Remove the child restraint fixing system.
3.
Allow the belt webbing to be pulled in com‐
pletely.
LATCH child restraint fixing
system
LATCH: Lower Anchors and Tether for CHil‐
dren.
Note
Manufacturer's information for LATCH
child restraint fixing systems
To mount and use the LATCH child restraint fix‐
ing systems, observe the operating and safety
information from the system manufacturer; oth‐
erwise, the level of protection may be re‐
duced.◀
Mounts for the lower LATCH anchors
Correctly engage the lower LATCH an‐
chors
Make sure that the lower LATCH anchors have
properly engaged and that the child restraint fix‐
ing system is resting snugly against the back‐
rest; otherwise, the degree of protection offered
may be reduced.◀
Mounts for the lower LATCH anchors are lo‐
cated in the gap between the seat and backrest.
Before mounting the LATCH child restraint fix‐
ing system, pull the belt away from the child re‐
straint fixing system.
Mounting LATCH child restraint fixing
systems without power rear seats
1.
Mount the child restraint fixing system; refer
to the operating instructions of the system.
2.
Make sure that both lower LATCH anchors
have properly engaged and that the child re‐
straint fixing system is resting snugly
against the backrest.
Mounting LATCH child restraint fixing
systems on power rear seats*
1.
Before mounting, adjust the seats to their
basic position, refer to page 53
.
Seite 63
63
Online Edition for Part no. 01 41 2 603 958 - 03 10 500