Performing the system reset procedure, 370 wheels and tires – FORD 2013 F-550 v.3 User Manual

Page 371

Advertising
background image

Performing the System Reset Procedure

Read the entire procedure before attempting.

1. Drive the vehicle above 20 mph (32 km/h) for at least two minutes
and then park in a safe location where you can easily get to all four tires
and have access to an air pump.

2. Place the ignition in the off position and keep the key in the ignition.

3. Cycle the ignition to the on position with the engine off.

4. Turn the hazard flashers on then off three times. This must be
accomplished within 10 seconds.

If the reset mode has been entered successfully, the horn will sound
once, the system indicator will flash and a message is shown in the
information display (if equipped). If this does not occur, please try again
starting at Step 2.

If after repeated attempts to enter the reset mode, the horn does not
sound, the system indicator does not flash and no message is shown in the
information display (if equipped), seek service from your authorized dealer.

5. Note: Train the tire pressure monitoring system sensors in the tires
using the following system reset sequence starting with the left front tire
in the following clockwise order:
• Left front (Driver’s side front tire)
• Right front (Passenger’s side front tire)
• Right rear (Passenger’s side rear tire)
• Left rear (Driver’s side rear tire)
6. Remove the valve cap from the valve stem on the left front tire;
decrease the air pressure until the horn sounds.

Note: The single horn chirp confirms that the sensor identification code
has been learned by the module for this position. If a double horn is
heard, the reset procedure was unsuccessful, and must be repeated.

7. Remove the valve cap from the valve stem on the right front tire;
decrease the air pressure until the horn sounds.

8. Remove the valve cap from the valve stem on the right rear tire;
decrease the air pressure until the horn sounds.

9. Remove the valve cap from the valve stem on the left rear tire;
decrease the air pressure until the horn sounds.

Training is complete after the horn sounds for the last tire trained
(driver’s side rear tire), the system indicator stops flashing, and a
message is shown in the information display (if equipped).

370

Wheels and Tires

2013 F-250/350/450/550 (f23)
Owners Guide gf, 3rd Printing, December 2012
USA
(fus)

Advertising
This manual is related to the following products: