Tire change procedure, 376 wheels and tires – FORD 2013 F-550 v.3 User Manual

Page 377

Advertising
background image

6. Lift the spare tire on end to
access the tether attachment.

7. Use the lug wrench to remove
the lug nut from the spare tire
tether.

8. If not replacing the spare or flat
tire to the underbody storage area,
raise the wheel retainer up into the
installed position.

9. Use the attached fastener strap (on the spare tire tether) to attach the
tether end to the winch retainer prior to raising to the installed position.

Tire Change Procedure

WARNING: When one of the front wheels is off the ground, the
transmission alone will not prevent the vehicle from moving or

slipping off the jack, even if the transmission selector lever is in
position P.

WARNING: To help prevent the vehicle from moving when you
change a tire, be sure to place the transmission selector lever in

position P, set the parking brake and block (in both directions) the
wheel that is diagonally opposite (other side and end of the vehicle) to
the tire being changed.

WARNING: Never get underneath a vehicle that is supported
only by a jack. If the vehicle slips off the jack, you or someone

else could be seriously injured.

WARNING: Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off the road to avoid

the danger of being hit when operating the jack or changing the wheel.

376

Wheels and Tires

2013 F-250/350/450/550 (f23)
Owners Guide gf, 3rd Printing, December 2012
USA
(fus)

Advertising
This manual is related to the following products: