FORD 2013 F-550 v.3 - Manual (Page 69)

Optional Settings
You can configure these settings while programming a MyKey or change
them while using an admin key:
• 80 mph (130 km/h) vehicle speed limit. Drivers receive visual
warnings and an audible tone when they reach 80 mph (130 km/h).
• 45, 55 or 65 mph (75, 90, or 105 km/h) vehicle speed warning. Drivers
receive visual warnings and an audible tone when they exceed the
preselected vehicle speed.
• 45% of the maximum audio system output. The audio system displays
a message when drivers attempt to exceed the volume limits.
• AdvanceTrac. Program the system to Always-on and these features,
if your vehicle is equipped, cannot be turned off when drivers use a
programmed MyKey.
CREATING A MYKEY
Use the information display to create a MyKey.
For Type 1 information displays:
1. Insert the key you want to program into the ignition.
2. Switch the ignition on.
3. Access the main menu within the information display, and press
SETUP using the information display button until PRESS RESET
TO CREATE MYKEY displays.
4. Press and release the RESET button. The message HOLD RESET
TO CONFIRM MYKEY will display.
5. Press and hold the RESET button for two seconds until MARK
THIS AS RESTRICTED displays. Wait until KEY RESTRICTED
AT NEXT START displays, confirming that your key is successfully
created.
Make sure you label your key so you can distinguish it from the admin
keys.
For Type 2 information display controls:
1. Insert the key you want to program into the ignition.
2. Switch the ignition on.
3. From the main menu within the information display, use the right
arrow key > or OK to select SETTING and then MYKEY.
4. Press > or OK to select CREATE MYKEY.
5. Hold OK as prompted until you see MARK THIS KEY AS
RESTRICTED in the information display screen.
68 MyKey
2013 F-250/350/450/550 (f23)
Owners Guide gf, 3rd Printing, December 2012
USA (fus)