NISSAN 2013 Armada - Owner's Manual - Manual (Page 153)

REPROGRAMMING A SINGLE
HOMELINK
ா BUTTON
To reprogram a HomeLink
ா Universal Transceiver
button, complete the following:
1. Press and hold the desired HomeLink ா but-
ton. DO NOT release the button.
2. The indicator light will begin to flash after
20 seconds. Without releasing the
HomeLink ா button, proceed with “Program-
ming HomeLink ா” - Step 1.
For questions or comments, contact HomeLink ா
at: www.homelink.com or 1–800–355–3515.
The HomeLink ா Universal Transceiver button has
now been reprogrammed. The new device can
be activated by pushing the HomeLink
ா button
that was just programmed. This procedure will
not affect any other programmed HomeLink
ா
buttons.
IF YOUR VEHICLE IS STOLEN
If your vehicle is stolen, you should change the
codes of any non-rolling code device that has
been programmed into HomeLink
ா. Consult the
Owner’s Manual of each device or call the manu-
facturer or dealer of those devices for additional
information.
When your vehicle is recovered, you will
need to reprogram the HomeLink
ா Univer-
sal Transceiver with your new transmitter
information.
FCC Notice:
For USA:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) This device may
not cause harmful interference, and (2) this
device must accept any interference re-
ceived, including interference that may
cause undesired operation. Note: Changes
or modifications not expressly approved by
the party responsible for compliance could
void the user’s authority to operate the
equipment.
For Canada:
This device complies with RSS-210 of In-
dustry Canada. Operation is subject to the
following two conditions: (1) this device
may not cause interference, and (2) this
device must accept any interference, in-
cluding interference that may cause unde-
sired operation of the device.
2-62 Instruments and controls