Entry/exit function -38 – NISSAN 2013 Armada - Owner's Manual User Manual

Page 191

Advertising
background image

2. While the indicator light for the memory

switch being set is illuminated for 5 sec-
onds, press the

button on the keyfob.

The indicator light will blink. After the indica-
tor light goes off, the keyfob is linked to that
memory setting.

With the key removed from the ignition switch or
the ignition switch is moved to OFF, press
the

button on the keyfob. The driver’s seat,

accelerator and brake pedals, and outside mir-
rors will move to the memorized position.

NOTE:

If a new memory position is saved to the
memory switch, the keyfob automatically
re-links.

Confirming memory storage

● Place the ignition switch in the ON position

and push the SET switch. If the main memory
has not been stored, the indicator light will
come on for approximately 0.5 seconds.
When the memory has stored the position,
the indicator light will stay on for approxi-
mately 5 seconds.

● If the battery cable is disconnected, or if the

fuse opens, the memory storage function will
be canceled and must be restarted before a
stored memory position can be set again.
Drive the vehicle over 25 MPH (40 km/h) to
restart the memory storage function. You
can also restart the memory storage function
using the following procedure.

1. Connect the battery cable or replace the

fuse.

2. Open and close the driver’s door more than

2 times with the ignition switch in the LOCK
position.

Once the memory storage function has been
restarted, you can store a memory position.
See “Memory storage function” in this sec-
tion.

Selecting the memorized position

Set the shift selector to the P (Park) position,
then:

● Within 45 seconds of opening the driver’s

door, push the memory switch (1 or 2) or

● Place the ignition switch in the ON position

and push the memory switch (1 or 2).

The driver’s seat, accelerator and brake pedals,
and outside mirrors will move to the memorized

position with the indicator light blinking, and then
the light will stay on for approximately 5 seconds.

ENTRY/EXIT FUNCTION

This system is designed so that the driver’s seat
will automatically move when the shift selector is
placed in the P (Park) position. This allows the
driver to get into and out of the driver’s seat more
easily.

The driver’s seat will slide backward:

● When the key is removed from the ignition

switch and the driver’s door is opened.

● When the driver’s door is opened with the

ignition switch placed in the LOCK position.

● When the ignition switch is turned from

ACC to LOCK with the driver’s door open.

The driver’s seat will return to the previous posi-
tion:

● When the key is inserted into the ignition

switch and the driver’s door is closed.

● When the driver’s door is closed with the

ignition switch placed in the LOCK position.

● When the ignition switch is turned from

ACC to ON while the shift selector is in the P
(Park) position.

3-38

Pre-driving checks and adjustments

Advertising