NISSAN 2015 JUKE - Owner's Manual - Manual (Page 108)

SIC3664
Type A (if so equipped)
JVI1010X
Type B (if so equipped)
The windshield wiper and washer operates
when the ignition switch is in the ON position.
Push the lever down to operate the wiper at the
following speed:
*
1 Intermittent — intermittent operation can be
adjusted by turning the knob toward
*
A
(Slower) or
*
B (Faster).
*
2 Low — continuous low speed operation
*
3 High — continuous high speed operation
Push the lever up
*
4 to have one sweep
operation of the wiper.
Pull the lever toward you
*
5 to operate the
washer. Then the wiper will also operate several
times.
Pulling up the wiper arm:
The windshield wipers must be in the service
position in order to replace the wiper blades.
To move the wiper blades to the service position,
follow this procedure:
. When the ignition switch is in the “ON”
position or within 60 seconds of placing the
ignition switch to the “OFF” position, lift the
lever up
*
4 two times in less than 0.5
seconds. The windshield wipers will move to
the service position automatically, and the
wiper blades can now be replaced. To
replace the wiper blades, see “Windshield
wiper blades” (P.8-18).
To move the wiper blades back to the original
position:
. Lift the lever up
*
4 or push the lever down
to operate at any wiper speed.
CAUTION
. This function can be operated even
if the ignition switch is in the “ON”
position. However, to prevent an
accident or damage when pulling
up the wiper arm, be sure to observe
the following precautions.
— Make sure the shift lever is in
the P (Park) position (Continu-
ously Variable Transmission
models).
— Make sure the shift lever is in
the N (Neutral) position, with the
parking brake fully applied
(Manual Transmission models).
— Never allow the passengers to
operate the windshield wiper
switch inadvertently.
. Do not operate the windshield wiper
while the wiper arm is pulled up. The
wiper arm may be damaged.
Instruments and controls 2-33