Warning – NISSAN 2015 JUKE - Owner's Manual User Manual
Page 231
4-80
Heater, air conditioner, audio and phone systems
another call is already active, a message will be
displayed on the screen. Push the
button to
hold the active call and switch to the second
call. Push the
button to reject the second
call.
While the second call is active, pushing the
button will allow the same commands that
available during any call as well as two additional
commands:
. Switch Call
Speak this command to hold the second call
and switch back to the original call.
. End Other Call
Speak this command to stay with the
second call and end the original call.
Push the
button to accept the call. Push the
button to reject the call.
Ending a call
To end an active call, push the
button.
Text messaging
WARNING
. Laws in some jurisdictions may
restrict the use of some of the
applications and features, such as
social networking and texting.
. Laws in some jurisdictions may
restrict the use of “Text-to-Speech”.
Check local regulations before
using this feature.
. Use the text messaging feature after
stopping your vehicle in a safe
location. If you have to use the
feature while driving, exercise ex-
treme caution at all times so full
attention may be given to vehicle
operation.
. If you are unable to devote full
attention to vehicle operation while
using the text messaging feature,
pull off the road to a safe location
and stop your vehicle.
NOTE:
This feature is automatically disabled if the
connected device does not support the
Message Access Profile (MAP). See the
phone’s Owner’s Manual for details and
instructions.
The system allows for the sending and receiving
of text messages through the vehicle interface.
Sending a text message:
1. Push the
button.
2. Say “Messaging”.
3. Say “Send Text”.
4. The system will provide a list of available
commands in order to determine the reci-
pient of the text message. Choose from the
following:
.
(A name)
.
Number
.
Incoming Calls
.
Outgoing Calls
.
Missed Calls
If “Incoming Calls”, “Outgoing Calls”, or
“Missed Calls” is selected, the following
additional commands will be displayed:
.
Send Text
.
Next Entry
.
Previous Entry
For more information about these options,
see “Voice commands” (P.4-77).
5. Once a recipient is chosen, the system
prompts for which message to send. Five
predefined messages are available as well
as three custom messages. To choose one
of the predefined messages, speak one of
the following: