NISSAN 2015 JUKE - Owner's Manual - Manual (Page 181)

4-30 Heater, air conditioner, audio and phone systems
. To remove moisture or fog on the front
window quickly, set the temperature to
the high temperature and the fan speed
to their maximum level.
. After the windshield is cleared, push the
front defroster button again. (The
indicator light will turn off.)
. When the front defroster button is
pushed, the air conditioner will automa-
tically turn on to defog the windshield.
The outside air circulation mode will be
selected to improve the defogging per-
formance.
. When the position is selected, the
air recirculation mode cannot be turned
on to prevent the windows from being
fogged up.
Manual operation
The manual mode can be used to control the
heater and air conditioner to your desired
settings.
To turn off the heater and air conditioner, push
the OFF button.
If the Drive Mode is indicated on the screen,
push the CLIMATE button to change to the
Climate Control Mode, then push the OFF
button.
Fan speed control:
Turn the fan speed control dial to adjust the
fan speed.
Air flow control:
Push the air flow control buttons to change the
air flow mode:
— Air flows from the center and side
ventilators.
— Air flows from the center and side
ventilators and foot outlets.
— Air flows mainly from the foot outlets.
— Air flows from the defroster outlets and
foot outlets.
Temperature control:
Turn the temperature control dial to set the
preferred temperature.
The temperature range is between 60 8F (188C)
and 90 8F (328C).
Air recirculation:
Push the air intake button to change the air
circulation mode. When the indicator light
illuminates, the flowing air is recirculated inside
the vehicle.
. When the
or position is selected,
the air recirculation mode cannot be turned
on to prevent the windows from being
fogged up.
Outside air circulation:
Push the air intake button to change the air
circulation mode. When the indicator light
illuminates, the flowing air is drawn from outside
the vehicle.
Automatic air intake control:
Push and hold the outside air circulation “ ”
/air recirculation “ ” button for more than 1.5
seconds to set the automatic control between
the outside air circulation and air recirculation
modes.
When the “ ” or “ ” position is selected,
the air recirculation mode does not activate.
When setting the automatic control mode, the
indicator lights “
” and “ ” will blink twice
indicating that the system is in the automatic
control mode.