NISSAN 2015 JUKE - Owner's Manual - Manual (Page 114)

Instrument brightness control
The instrument brightness control operates
when the ignition switch is in the ON position.
Push the control knob
*
A to adjust the bright-
ness of the instrument panel lights. The bright-
ness indicator
*
B will be shown briefly in the
vehicle information display when the control is
turned.
When the brightness level reaches the maximum
or minimum, a beep will sound.
SIC3671
TURN SIGNAL SWITCH
*
1 Turn signal
Move the lever up or down to signal the turning
direction. When the turn is completed, the turn
signals cancel automatically.
*
2 Lane change signal
Move the lever up or down until the turn signal
begins to flash, but the lever does not latch, to
signal a lane change. Hold the lever until the lane
change is completed.
Move the lever up or down until the turn signal
begins to flash, but the lever does not latch, and
release the lever. The turn signal will automati-
cally flash three times.
Choose the appropriate method to signal a lane
change based on road and traffic conditions.
Instruments and controls 2-39