NISSAN 2013 LEAF - Owner's Manual - Manual (Page 275)

mode or press the PHONE/END ( )
button to select a different language.”
3. Press the button.
For information on voice adaptation, see
“Voice Adaptation (VA) mode” in this section.
4. The system announces the current language
and gives you the option to change the lan-
guage to Spanish (in Spanish) or French (in
French). To select the current language, press
the PHONE/SEND (
) button. To select
a different language, tilt the tuning switch (
or ) up or down.
NOTE:
You must press the
button within 5
seconds to change the language.
5. If you decide not to change the language, do
not press either button. After 5 seconds, the
VR session will end, and the language will not
be changed.
Connecting procedure
NOTE:
The connecting procedure must be per-
formed when the vehicle is stationary. If the
vehicle starts moving during the procedure,
the procedure will be cancelled.
Main Menu
“Add phone”
᭺
A
Initiate from handset
᭺
B
Name phone
᭺
C
1. Press the button on the steering wheel.
The system announces the available
commands.
2. Say: “Add phone”
᭺
A . The system acknowl-
edges the command and asks you to initiate
connecting from the phone handset
᭺
B .
The connecting procedure of the cellular
phone varies according to each cellular phone
model. See the cellular phone Owner’s
Manual for details. You can also visit
www.NissanUSA.com/bluetooth for instruc-
tions on connecting NISSAN recommended
cellular phones.
When prompted for a Passkey code, enter
“1234” from the handset. The Passkey code
“1234” has been assigned by NISSAN and
cannot be changed.
3. The system asks you to say a name for the
phone
᭺
C .
If the name is too long or too short, the system
tells you, then prompts you for a name again.
Also, if more than one phone is connected and
the name sounds too much like a name already
used, the system tells you, then prompts you
for a name again.
Making a call by entering a phone
number
Main Menu
“Call”
᭺
A
“Phone number”
᭺
B
Speak the digits
᭺
C
Dial
᭺
D
1. Press the button on the steering wheel.
A tone will sound.
2. Say: “Call”
᭺
A . The system acknowledges the
command and announces the next set of
available commands.
3. Say “Phone Number”
᭺
B . The system ac-
knowledges the command and announces
the next set of available commands.
4. Say the number you wish to call starting with
the area code in single digit format
᭺
C . If the
system has trouble recognizing the correct
phone number, try entering the number in the
following groups: 3-digit area code, 3-digit
4-50 Heater, air conditioner, audio and phone systems