NISSAN 2013 LEAF - Owner's Manual User Manual

Page 328

Advertising
background image

REMOVING SPOTS

Remove tar and oil spots, industrial dust, insects,
and tree sap as quickly as possible from the paint
surface to avoid lasting damage or staining. Spe-
cial cleaning products are available at a NISSAN
certified LEAF dealer or any automotive acces-
sory stores.

UNDERBODY

In areas where road salt is used in winter, the
underbody must be cleaned regularly. This will
prevent dirt and salt from building up and causing
the acceleration of corrosion on the underbody
and suspension. Before the winter period and
again in the spring, the underseal must be
checked and, if necessary, re-treated.

GLASS

Use glass cleaner to remove smoke and dust film
from the glass surfaces. It is normal for glass to
become coated with a film after the vehicle is
parked in the hot sun. Glass cleaner and a soft
cloth will easily remove this film.

CAUTION

When cleaning the inside of the win-
dows, do not use sharp-edged tools,

abrasive cleaners or chlorine-based dis-
infectant cleaners. They could damage
the electrical conductors, radio antenna
elements or rear window defroster ele-
ments.

SOLAR CELL MODULE (IF SO
EQUIPPED)

The solar cell uses a plastic cover. When clean-
ing the cell:

• Do not polish the solar cell using a dry cloth or a

wax that contains a compound. Doing so may
strip off the hard coating.

• In order to maintain the solar cell’s effective-

ness, be sure to remove any leaves or dirt from
the surface of the cell.

WHEELS

Wash the wheels when washing the vehicle to
maintain their appearance.

• Clean the inner side of the wheels when the

wheel is changed or the underside of the vehicle
is washed.

• Inspect wheel rims regularly for dents or corro-

sion. Such damage may cause loss of pressure
or poor seal at the tire bead.

• NISSAN recommends that the road wheels be

waxed to protect against road salt in areas
where it is used during winter.

CAUTION

Do not use abrasive cleaners when wash-
ing the wheels.

Aluminum alloy wheels

Wash regularly with a sponge dampened in a
mild soap solution, especially during winter
months in areas where road salt is used. Salt
could discolor the wheels if not removed.

CAUTION

Follow the directions below to avoid
staining or discoloring the wheels:
• Do not use a cleaner that uses strong

acid or alkali contents to clean the
wheels.

• Do not apply wheel cleaners to the

wheels when they are hot. The wheel
temperature should be the same as
ambient temperature.

• Rinse the wheel to completely remove

the cleaner within 15 minutes after the
cleaner is applied.

Appearance and care

7-3

Advertising