NISSAN 2011 Murano - Owner's Manual - Manual (Page 301)

Black plate (301,1)
[ Edit: 2011/ 7/ 12 Model: Z51-X ]
SAA1858
CONTROL BUTTONS
1. PHONE SEND button
Push the button to initiate a VR session or
answer an incoming call. You can also use
the button to skip through system feedback
and to enter commands during a call.
2. PHONE END button
Push the button to cancel a VR session or
end a call.
VOICE RECOGNITION SYSTEM
You can also use the Bluetooth ® hands-free
phone system with Voice Recognition System.
INFO
. The available voice commands are only
applicable to the relevant language set in
the LANGUAGE setting screen. (See “How
to use SETTING button” earlier in this
section.)
. If the vehicle is in motion, some commands
may not be available so full attention may be
given to vehicle operation.
. The voice recognition system cannot be
operated when the soft top (CrossCabriolet
models) is open.
Manual command selection
Commands can be selected manually. While the
commands are displayed on the screen, select a
command by operating the Tune switch, and
then push the PHONE SEND
button. Once
a command is manually selected, the voice
command function is cancelled. To return to
voice command mode, push the PHONE END
button to cancel the current operation, and
then perform the first procedure of voice
command.
Using system
Initialization:
When the ignition switch is pushed to the ON
position, Voice Recognition System is initialized,
which may take up to one minute. When
completed, the system is ready to accept voice
commands. If the
switch on the steering
wheel is pushed before the initialization com-
pletes, the system will not accept any command.
Before starting:
To get the best performance out of the Voice
Recognition System, observe the following:
. Keep the interior of the vehicle as quiet as
possible. Close the windows to eliminate the
surrounding noises (traffic noises, vibration
sounds, etc.), which may prevent the system
from recognizing the voice commands cor-
rectly.
. Wait until a tone sounds before speaking a
command.
. Speak a voice command within 5 seconds
after the beep sound. If no voice command
is given, the system will ask you for a
number. If no further command is given,
the session ends.
. Speak in a natural voice without pausing
between words.
Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-97