NISSAN 2014 Rogue - Owner's Manual - Manual (Page 122)

Headlight beam select
᭺
1 To select the high beam function, push the
lever forward. The high beam lights come on
and the
light illuminates.
᭺
2 Pull the lever back to select the low beam.
᭺
3 Pulling and releasing the lever flashes the
headlight high beams on and off.
Battery saver system
The battery saver automatically turns off the igni-
tion after a period of time when the ignition switch
is left in the ACC (if so equipped) or ON position.
DAYTIME RUNNING LIGHT SYSTEM
The daytime running lights automatically illumi-
nate when the engine is started with the parking
brake released. The daytime running lights oper-
ate with the headlight switch in the OFF position
or in the
position. Turn the headlight switch
to the position for full illumination when
driving at night.
If the parking brake is applied before the engine is
started, the daytime running lights do not illumi-
nate. The daytime running lights illuminate when
the parking brake is released. The daytime run-
ning lights will remain on until the ignition switch
is placed in the OFF position.
WARNING
When the daytime running light system is
active, tail lights on your vehicle are not
on. It is necessary at dusk to turn on your
headlights. Failure to do so could cause
an accident injuring yourself and others.
INSTRUMENT BRIGHTNESS
CONTROL
Push the “-” button
᭺
A to decrease the bright-
ness of instrument panel lights when driving at
night.
Push the “+” button
᭺
B to increase the bright-
ness of instrument panel lights when driving at
night.
LIC2637 LIC2624
Instruments and controls 2-37