NISSAN 2015 Xterra - Owner's Manual User Manual

Page 40

Advertising
background image

Attaching the center seat belt

Always be sure the center seat belt connector
tongue and connector buckle are attached. Dis-
connect only when folding down the rear seat.

To connect the buckle:

1. Pull out the seat belt tongue

E

from the

retractor base.

2. Pull out the connector tongue

F

from the

molded retractor base.

3. Pull the seat belt

G

and secure the receiver

buckle until it clicks.

The center seat belt connector tongue and re-
ceiver buckle are indicated by the > and < mark.

The center seat belt connector tongue can be
attached only into the rear center seat belt con-
nector buckle.

To fasten the seat belt, for additional information,
refer to “Fastening the seat belts” in this section.

WARNING

Do not unfasten the rear center seat

belt connector except when folding
down the rear seat.

When attaching the rear center seat belt

connector, be certain that the seat-
backs are completely secured in the
latched position and the rear center
seat

belt

connector

is

completely

secured.

If the rear center seat belt connector

and the seatbacks are not secured in
the correct position, serious personal
injury may result in an accident or sud-
den stop.

Rear center seat belt comfort guide

When using the rear seat center seat belt it may
be necessary to use the comfort guide to adjust
the shoulder belt height for occupants of different
sizes for added comfort and to help obtain proper
seat belt fit.

1. Raise the head restraint/headrest

A

on the

rear seat driver’s side seating position. Re-
move the comfort guide

B

from the stowed

position by pulling the cord from the chan-
nel.

LRS2493

Safety—Seats, seat belts and supplemental restraint system

1-21

Advertising