Hudson Robotics LabLinx - Manual (Page 10)

StackLink User Manual Hudson Robotics, Inc.
6
Setting up the StackLink
 Remove the StackLink from the carton and carefully remove the protective plastic
covering.
 Un-wrap any TrackLinks and/or StopLinks included.
 Remove the Stacks from the carton, then remove the stack from the packaging
 Install the supplied Stacks on the StackLink securely.
Setting up the TrackLink(s)
 Position the TrackLink into either side of the StackLink and insert the track so the
groves match and fit into place (Figure 7).
 NOTE: Be sure the TrackLink and StackLink gearing is properly positioned and
aligned for correct operation
 Secure the track with the included Clamp Bars (Figure 11). Repeat if connecting
an additional TrackLink if required.
 Secure the TrackLink to any instrument nests.
 NOTE: Calibration and/or origin adjustments may need to be set for these
instruments. (I.E. PlateCrane positions, Micro10 dispensing origin, etc.)
Figure 7