Chapter 6-hardware specifications, General, Tracklink – Hudson Robotics LabLinx User Manual
Page 21: Stoplink, Mechanical description
StackLink User Manual
Hudson Robotics, Inc.
17
CHAPTER 6-Hardware Specifications
General
Note: Specifications are subject to change without notice.
Plate Capacity:
Standard-- Up to 30 plates without lids or 25 plates
with lids.
Additional-- Up to 120 plates without lids or up to 100
plates with lids.
Plate Storage Device:
2 removable stacks (Double Stacks available)
Housing Material:
Painted steel covering cast aluminum housing.
Gripper Material:
Black anodized aluminum; textured neoprene rubber
inserts.
DriveLink length:
15 inches
TrackLink
Gearing:
Guarded power transmitting shaft assembly
Pulley System:
2 - 3/16” wide 1/5 pitch timing belts
Available Lengths:
24” and 36” tracks
Maximum Track Length:
159” (up to 4 -36” tracks) for 1 StackLink
StopLink
Plate Detection:
Photoelectric sensor
Stopping Mechanism:
2 plate stop fingers (left & right) operated by rotary
solenoids
Communication:
13” coiled cord (8 pos RJ-12 modular plug)
Mechanical Description
DriveLink Motor:
AC reversible motor 110V 60Hz
DriveLink Gearhead:
Frame #2, 200 RPM
Elevator Lift:
Pneumatic lift cylinder assembly
Plate Gripper:
Pneumatic fired gripper pads (10mm bore, 5mm stroke)
Pressurized Air Supply:
Regulator with filter and gauge (1/4” air supply fitting)