Hudson Robotics LabLinx - Manual (Page 23)

StackLink User Manual Hudson Robotics, Inc.
19
CHAPTER 7-Maintenance
Maintenance
WARNING- -

Qualified personnel can perform all maintenance procedures in this
manual. Only Hudson representatives should perform any maintenance
not discussed in this manual.

Gloves should be worn during any cleaning procedure.
Cleaning the StackLink

Note: DO NOT use/spray abrasive cleaners onto the StackLink.
 Clean the outside surfaces of StackLink and/or TrackLink using cloth or sponge
dampened with alcohol, water, or mild glass cleaner.
 Clean finger pads of gripper with alcohol or other residue-free solvent.
 Clean any spills on the StackLink, TrackLink, or StopLink immediately.
 Only clean the exterior of the unit. DO NOT remove instrument covers to clean
inside.
 Never allow water or fluid to leak inside the StackLink.
Change the Fuse(s)
Fuses burn out occasionally and must be replaced. The following fuses are used with the
StackLink:
 Metric: 1 x 2 amp, 5 x 20 mm Time Delay Fuse
WARNING- -

Be sure the power to the StackLink is OFF and the power cord is
unplugged from the instrument or power source before proceeding with
the following instructions.

Turn the StackLink OFF and remove the power cord from the AC inlet on the back
of the unit.