Hudson Robotics LabLinx - Manual (Page 24)

StackLink User Manual Hudson Robotics, Inc.
20

Using a small flat head screwdriver, gently pry the fuse holder tray away from its
housing to access the fuses. The Fuse holder door swings down.

Remove the blown fuse. Replace it with the spare fuse.

Slide the fuse holder tray back into the AC inlet until it clicks. Make sure when re-
installing the holder the AC line voltage reads the correct way on the inlet

Reconnect the power cord to the StackLink and reconnect all other cables
previously disconnected.

Verify correct fuse replacement by turning the StackLink switch to ON position--
the light will illuminate immediately.
Figure 15
Location of fuse
holder tray