Jeppesen FliteDeck Pro (iOS) - Manual (Page 16)

Getting Started
FliteDeck Pro Global Settings
October 2014 Jeppesen FliteDeck Pro User Guide
Copyright © 2014 Jeppesen. All rights reserved.
9
Terminal Charts View
These settings control the display of the Terminal Charts view.
• To display ownship position on the airport diagram, switch
Display Ownship on Airport Diagram to ON. This setting
is OFF by default.
The minimum GPS accuracy requirement to display
ownship on a taxi diagram is 17 meters.
• Default Chart Zoom Level is the zoom level preference
for viewing terminal charts. Values are Fit Full Chart and
Fit to Width. Fit Full Chart is the default value.
• Arpt Diagram (10-9) Speed Threshold is the speed at
which, if enabled, the automatic switch to a taxi diagram
occurs. It is also the speed threshold at which the ownship
appears on the airport diagram.
You can optimize this setting for your aircraft by adjusting
the threshold speed. Values range from 30 to 80 knots.The
setting is 40 knots by default.
Note that a GPS signal is required for the automatic switch
to a taxi diagram. The accuracy requirement to display
ownship on a taxi diagram is 17 meters.
NOTE Displaying the ownship position symbol on the airport
diagram is designed to assist flight crews in orienting
themselves on the airport surface and improving pilot positional
awareness during taxi operations. This function is not to be
used as the basis for ground maneuvering and is limited to
ground operations.
Appropriate flight crew member training and procedures
emphasize set up and operation such that the display should
not become a distraction or increase heads down time.
Operators may require additional authorizations to use this
function in flight.