Kraus C-GV-710-12mm-15000ORB - Manual (Page 5)

Installation Instructions
Finished Wall
1 3/4” Drain Hole
Vessel Sink
Mounting Ring
Thin Soft Rubber Washer
Pop Up Drain
Concave Washer
Nut
DO NOT OVER TIGHTEN THE DRAIN!!!
Tail Pipe
Firm Washer
Pop Up Drain Top
1 3/4”
Counter Top
(Suggested)
14” - 17”
Countertop
5 1/2” 6”
34”
Suggest
ed
28”
Suggest
ed
Floor
Mounting Ring 1/2”
Top View
Mounting Ring
White Rubber Washer
Top View
Inner Black Rubber Washer
Bottom View
Before you begin
Prepare counter top by drilling a 1 3/4’’ diameter drain hole at the desired location. Install
mounting ring. Place vessel sink on the mounting ring or counter top as shown below.
1. Make sure the vessel sink is not scratched, chipped or broken prior
to installation.
2. Check to see if your set contains the following parts:
• Vessel sink
• Pop up drain (optional, may be sold separately)
• Mounting Ring (optional, may be sold separately)
3. Locate and place the mounting ring over the drain hole with the
rubber side facing down and the white washer side facing up.
4. Gently set your sink on top of the mounting ring.