Dodge 2010 Journey - User Guide - Manual (Page 13)

• Place the child upright in the seat with
their back firmly against the seatback.
• Grasp the latch plate and pull out the
seat belt.
• Slide the latch plate up the webbing as
far as necessary to allow the seat belt to
go around the child’s lap.
NOTE: The lap portion of the seat belt should be low on the hips and as snug as
possible.
• Once the seat belt is long enough to fit properly, insert the latch plate into the
buckle until you hear a “click.”
• To remove the slack from the lap belt, pull upward on the shoulder portion of the
seat belt.
Installing The LATCH - Compatible Child Restraint System
• Your vehicle’s second row passenger seats are equipped with the child restraint
anchorage system called LATCH, which stands for Lower Anchors and Tether for
CHildren.
• All three second-row passenger seating positions have lower anchors that are capable
of accommodating LATCH-compatible child seats.
• Rigid fixed lower attachments can only be used in the outboard seating positions.
Flexible lower attachments can be used in all seating positions.
• When installing a child seat in the center seating position use one lower anchorage
from the outboard seating position and the center seat dedicated lower anchorage. If
two child seats are installed in adjacent seating positions you must use the vehicle
seat belt in the center seating position.
• You should NEVER install LATCH-compatible child seats so that two seats share a
common lower anchorage.
11
GETTING STARTED