Dodge 2010 Journey - User Guide - Manual (Page 45)

ELECTRONIC VEHICLE INFORMATION CENTER (EVIC)
• The EVIC features a driver interactive
display that is located in the instrument
cluster. Pressing the controls on the
steering wheel allows the driver to select
vehicle information and Personal Settings.
For additional information, refer to
Programmable Features in this guide.
• Press and release the MENU button and
the mode displayed will change between
Compass/Temperature, Trip, System Status,
and Personal settings.
• Press the STEP button to scroll through sub menus (i.e., Trip Functions, Avg. Fuel
Economy, DTE, Elapsed Time, and Units).
• Press and release the Compass/Temperature button for instant access to the
Compass/Temperature screens.
• Press the RESET button to RESET Trip Functions and change Personal Settings.
UNIVERSAL GARAGE DOOR OPENER
Programming HomeLink ®
Begin Programming
• The HomeLink ® buttons are located in the
sun visor.
• Erase all channels before you begin training
by holding the two outside buttons for up to
20 seconds until the red indicator flashes.
• Park your vehicle outside of the garage and turn the ignition switch to the ON/RUN
position.
• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink ® buttons
while keeping the indicator light in view.
• Simultaneously, press and hold both the chosen HomeLink ® button and the
hand-held transmitter button until the HomeLink ® indicator flash rate changes from a
slow to a rapidly blinking light, then release both the HomeLink ® and the hand-held
transmitter buttons. This may take up to 30 seconds, or longer in rare cases.
43
ELECTRONICS