Dodge 2010 Viper - User Guide - Manual (Page 14)

Child Restraint Tether Anchor
NOTE: It is recommended to complete this task first.
• There is a tether strap anchor located behind the child tether access cover behind the
passenger seat.
• To attach a child restraint tether strap:
• Move the seat forward.
• Move the seatback to its full forward position.
• Remove the child tether access cover by prying either side with a screwdriver or
similar tool, as shown.
• Pass the child restraint tether hook
through either opening in the seatback,
underneath the head restraint.
• Attach the tether hook to the anchor
loop.
• Move the seat to its farthest rearward
position. Apply body pressure to the seat
to be sure the seat adjusters have
latched.
• Return the seatback to an upright
position.
• Install the child restraint according to the
manufacturer’s directions.
• Remove slack from the tether strap
according to the child restraint
manufacturer’s directions.
WARNING!
An incorrectly anchored tether strap could lead to increased head motion and
possible injury to the child. Use only the anchor position directly behind the child seat
to secure a child restraint top tether strap.
GETTING STARTED
12