Dodge 2010 Viper - User Guide - Manual (Page 33)

Splitter Components
• The front of the ACR splitter is supported by
two stainless steel cables. These cables and
their attachments should be regularly
inspected.
• The splitter cables have an adjustment
capability, however it is recommended to
leave the splitter at the factory delivered
settings. The splitter cables may have some
slack while the vehicle is at rest. When the
splitter is loaded, and the cables are under
tension, the panel should be approximately
parallel to the bottom of frame.
• Solid polymer rub strips are attached to the
leading edge of the splitter panel. Regularly
inspect these rub strips to avoid damage to
the carbon fiber splitter panel.
CAUTION!
Replace rub strips when they are worn down to 3/8 in. (10 mm) on the front edge. This
will avoid damage to the carbon fiber panel.
• Regularly inspect the outboard knock-in
threaded insert to avoid premature splitter
wear (right and left side). Replace these
fasteners as needed in order to protect the
carbon fiber splitter panel.
31
PERFORMANCE/ACR