Dodge 2015 Durango - User Guide - Manual (Page 149)

Before You Begin Programming HomeLink®
• Be sure that your vehicle is parked out-
side of the garage before you begin pro-
gramming.
• For more efficient programming and
accurate transmission of the radio-
frequency signal it is recommended that
a new battery be placed in the hand-held
transmitter of the device that is being
programmed to the HomeLink
® system.
• Erase all channels before you begin pro-
gramming. To erase the channels, place
the ignition switch into the ON/RUN
position, then press and hold the two
outside HomeLink
® buttons (I and III) for up to 20 seconds or until the red indicator
flashes.
NOTE:
• Erasing all channels should only be performed when programming HomeLink
® for the
first time. Do not erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1-800-355-3515
or, on the Internet at www.HomeLink.com for information or assistance.
Programming A Rolling Code
NOTE:
For programming Garage Door Openers that were manufactured after 1995. These Garage
Door Openers can be identified by the “LEARN” or “TRAIN” button located where the
hanging antenna is attached to the Garage Door Opener. It is NOT the button that is
normally used to open and close the door. The name and color of the button may vary by
manufacturer.
1. Place the ignition switch into the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink
®
button you wish to program while keeping the HomeLink ® indicator light in view.
3. Push and hold the HomeLink ® button you want to program while you push and hold
the hand-held transmitter button.
4. Continue to hold both buttons and observe the indicator light. The HomeLink ®
indicator will flash slowly and then rapidly after HomeLink ® has received the fre-
quency signal from the hand-held transmitter. Release both buttons after the indicator
light changes from slow to rapid.
HomeLink® buttons
E L E C T R O N I C S
147