Dodge 2015 Durango - User Guide - Manual (Page 168)

Vehicles Equipped With Passive Entry
• Without pushing the brake pedal, push the ENGINE START/STOP button and cycle the
ignition to the ON/RUN position (Do not start the engine).
• Push and release the DOWN arrow button to scroll downward through the main
menu to “Vehicle Info.”
• Push and release the RIGHT arrow button to access the ”Oil Life” screen.
• Push and hold the RIGHT arrow button for one second to access the ”Oil Life Reset”
screen.
• Push and hold the DOWN arrow button until the screen shows 100% oil life.
• Push and release the Up arrow button to exit the DID screen.
Vehicles Not Equipped With Passive Entry
• Without pushing the brake pedal, cycle the ignition to the ON/RUN position (Do not
start the engine).
• Push and release the DOWN arrow button to scroll downward through the main
menu to “Vehicle Info.”
• Push and release the RIGHT arrow button to access the “Oil Life” screen.
• Push and hold the RIGHT arrow button for one second to access the “Oil Life Reset”
screen.
• Push and hold the DOWN arrow button until the screen shows 100% oil life.
• Push and release the Up arrow button to exit the DID screen.
NOTE:
If the indicator message illuminates when you start the vehicle, the oil change indicator
system did not reset. If necessary, repeat this procedure.
INSTRUMENT CLUSTER INDICATOR LIGHTS
- Low Fuel Warning Light
This warning light indicates when the fuel level reaches approximately 2.0 gal (7.8 L).
This light will turn on and a single chime will sound.
- Turn Signal Indicator
The arrows will flash with the exterior turn signals when the turn signal lever is operated.
A tone will chime, and a DID message will appear if either turn signal is left on for more
than 1 mile (1.6 km).
NOTE:
If either indicator flashes at a rapid rate, check for a defective outside light bulb.
W H AT T O D O I N E M E R G E N C I E S
166