Dodge 2015 Durango - User Guide - Manual (Page 41)

Front Wipers
Intermittent, Low And High Operation
Rotate the end of the lever to one of the first four detent positions for intermittent settings,
the fifth detent for low wiper operation and the sixth detent for high wiper operation.
Washer Operation
Push inward on the end of the lever and hold for as long as spray is desired.
Mist
Rotate the end of the lever downward when a single wipe is desired.
NOTE:
The mist feature does not activate the washer pump; therefore, no washer fluid will be
sprayed on the windshield. The wash function must be activated in order to spray the
windshield with washer fluid.
Rain Sensing Wipers
This feature senses moisture on the vehicle's windshield and automatically activates the
wipers for the driver when the switch is in the intermittent position. Rotate the end of the
lever to one of four settings to activate this feature and adjust sensitivity.
The Rain Sensing feature can be turned on and off using the Uconnect ® System. Refer to
the “Programmable Features” in the “Electronics” section in this guide.
Refer to the Owner's Manual on the DVD for further details.
Rear Wiper
Rear Wiper Operation
Rotate the center portion of the lever forward to the first detent for intermittent operation
and to the second detent for rear wiper operation.
Rear Washer Operation
Rotate the center portion of the lever past the second detent to activate the rear washer.
High Beam Operation
Push the lever forward to activate the high beams. Pull the lever toward you for flash to
pass.
NOTE:
For safe driving, turn off high beams when oncoming traffic is present to prevent headlight
glare and as a courtesy to other motorists.
O P E R AT I N G Y O U R V E H I C L E
39