Instrument cluster indicator lights, Turn signal indicator, High beam indicator – Dodge 2015 Journey - User Guide User Manual

Page 93: Front fog light indicator, Vehicle security light, Electronic speed control on indicator, Electronic speed control set indicator, Oil change due, Instrument cluster indicator, Lights

Advertising
background image

INSTRUMENT CLUSTER INDICATOR LIGHTS

- Turn Signal Indicator

The arrows will flash with the exterior turn signals when the turn signal lever is operated.
A tone will chime, and a EVIC message will appear if either turn signal is left on for more
than 1 mile (1.6 km).

NOTE:

If either indicator flashes at a rapid rate, check for a defective outside light bulb.

- High Beam Indicator

Indicates that headlights are on high beam.

- Front Fog Light Indicator

This indicator will illuminate when the front fog lights are on.

- Vehicle Security Light

This light will flash rapidly for approximately 15 seconds when the vehicle security alarm
is arming. The light will flash at a slower speed continuously after the alarm is set. The
security light will also come on for about three seconds when the ignition is first turned on.

- Electronic Stability Control (ESC) OFF Indicator Light

The ESC OFF indicator will illuminate when the Electronic Stability Control (ESC) is
turned off.

- Electronic Speed Control ON Indicator

This indicator will illuminate when the electronic speed control has been activated to the
“ON” position.

- Electronic Speed Control SET Indicator

This indicator will illuminate when the cruising speed has been set.

Oil Change Due

Your vehicle is equipped with an engine oil change indicator system. The “Oil Change
Due” message will display for 5 seconds along with a single chime to indicate the next
scheduled oil change interval. The engine oil change indicator system is duty cycle based,
which means the engine oil change interval may fluctuate dependent upon your personal
driving style.

W H AT T O D O I N E M E R G E N C I E S

91

Advertising