Canon COLORPASS-Z6000 PS-NX6000 - Manual (Page 44)

3-16
3
Connecting the ColorPASS
Shutting down and restarting
The ColorPASS will probably be left on all the time at the customer site. Remember that
when the ColorPASS is powered off, network access to the copier is interrupted.
Shut down the ColorPASS when you need to service it or the copier, and before you
remove or attach any cables to the ColorPASS. Shut down the ColorPASS before
changing the copier’s toner cartridge in order to prevent the fan from drawing toner into
the ColorPASS.
T O SHUT DOWN THE C OLOR PASS
Always verify that the ColorPASS is not in use before you shut it down.
1. Make sure Idle is displayed on the ColorPASS Control Panel.
When Printing or Ripping appears on the Control Panel, the ColorPASS is currently
processing a job. Idle is displayed on the Control Panel when the ColorPASS is finished
processing the job.
2. At the Idle screen, press the Menu button once to display the Functions menu.
3. Scroll to select Shut Down from the Functions menu.
4. At the next screen, select Shut Down System.
N OTE : If you are recycling power, wait at least 10 seconds before powering back on.
If you are unable to access the Shut Down menu to shut down the ColorPASS (for
example, if the system hangs), power off by holding down the power button for up to 8
seconds.
Print Pages
Scan Job
Suspend Printing
Resume Printing
Functions
Shut Down
Clear Server
Run Setup
Run Diagnostics
Functions
Use the line selection
button to the right to
select Shut Down
Restart Server
Shut Down System
Reboot System
Shut Down
Use the line selection
button to the right to
select Shut Down System