Canon COLORPASS-Z6000 PS-NX6000 - Manual (Page 78)

4-32
4
Service Procedures
Updating the system
After you have verified that the system functions properly with the new motherboard,
you must update the system by performing the following procedure.
N OTE : The following procedure assumes that the ColorPASS is fully assembled, powered
on, verified (see page 4-29), requires an update, and has the correct dongle attached.
T O UPDATE THE SYSTEM
1. Insert the Restore/Update Server Software CD in the DVD drive.
2. Shut down the ColorPASS (see page 4-4).
3. If you have not done so already, connect the dongle to the parallel port on the back of
the ColorPASS (see Figure 4-17 on page 4-30).
4. Power on the ColorPASS using the power button on the front panel.
The Update menu appears.
5. Scroll to “Update system”, and then select OK.
The Update system screen displays.
6. Select OK.
The update takes approximately 30 seconds while the message “Do NOT power off!”
displays on the Control Panel. Do not power off during the update. Doing so may
damage the ColorPASS.
Select Option:
Restore system
OK
Restore/Update CD
Select Option:
Update system
OK
Restore/Update CD
Select Option:
Exit
OK
Restore/Update CD
Press the 4th line selection button
Not used in this procedure
Uses remaining: 1
To cancel, remove
dongle and reboot.
OK
Update system
Press the 4th line selection button