Canon COLORPASS-Z6000 PS-NX6000 - Manual (Page 67)

4-21
4
Removing and replacing boards
T O REPLACE THE USER INTERFACE BOARD
1. Attach the UIB cable to the connector on the UIB.
Make sure the connector levers close securely around the cable connector.
2. Place the UIB against the bracket and align the mounting holes with the four mounting
posts (see Figure 4-12 on page 4-20).
3. Replace the four screws that secure the UIB to the bracket (see Figure 4-12 on
page 4-20).
Make sure you use the same screws you removed earlier.
4. Correctly orient the UIB buttons, and then mount them on the UIB.
F IGURE 4-14 Removing/replacing the UIB buttons
5. Replace the front panel (see Figure 4-4 on page 4-9).
6. Reassemble the ColorPASS (see page 4-14) and verify its functionality (see Figure 4-9
on page 4-16).
Button
orientation
UIB