Dell PowerEdge 2900 - Manual (Page 13)

Rack Installation Guide
11
Configuring the Sliding Rail Assemblies
The rotating mounting brackets on the mounting rails allow you to configure them as either RapidRails
or VersaRails. The mounting-bracket flange on the RapidRails configuration has two hooks and a push
button (see Figure 1-5). The mounting-bracket flange on the VersaRail has three holes (see Figure 1-6).
NOTE:
The rack kit ships with the sliding rail assemblies in the RapidRails configuration.
To rotate the mounting bracket and change the mounting rails from RapidRails to VersaRails
(see Figure 1-4):
1 Lift the release lever on the rotating mounting bracket.
2 Rotate the bracket and slide it up off the two shoulder standoffs.
3 Continue to rotate the bracket 180 degrees until you can set the notches back over the shoulder
standoffs.
4 Rotate the bracket back in the opposite direction on the shoulder standoffs until the bracket clicks
into place.
Figure 1-4. Rotating the Mounting Bracket
1 rotating mounting bracket 2 mounting-bracket flange
(RapidRails version shown) 3 release lever
4 mounting rails 5 shoulder standoff 6 notch
1
2
5
6
4
3