Dell LCD TV W3207C - Manual (Page 38)

38 Troubleshooting Problems With Your TV
www
.de
ll
.co
m |
sup
por
t.d
e
ll
.c
om
FILE LOCATION: C:\Documents and Settings\cherylyuan\Ƈ¦±\FM\ch5e.fm
DELL CONFIDENTIAL – PRELIMINARY 6/30/06 – FOR PROOF ONLY
TV Menu Messages
While using your TV, the following messages may appear.
Remote Control Problems
Message Possible Solution
Auto Adjust No action required, the TV is performing an auto adjustment.
Out of Range Check the optimal resolution settings.
You may need to download a new video driver. For more
information, go to support.dell.com.
No Video Input 1 Check all cables are properly connected.
2 Ensure the proper source is selected. See "Input Select" on page 26
for more information.
TV Buttons Locked To unlock, press Menu on your remote control, select Setup.
In Power Save Mode
Press any key on keyboard
or move mouse If you have a computer connected to the TV display and there is no
signal detected, the TV display goes in to sleep mode. The power
light is amber when the TV display is in sleep mode.
Self Test Appears for computer source when there is nothing plugged in.
Select VGA from Input Select menu and nothing is plugged in.
Plug a computer in to the VGA connector.
Problem Possible Solution
The TV does not respond when using
the remote control
1 Point the remote control directly at the lower right corner of the
TV display. Be sure that nothing is blocking the front of the TV
display. For the location of the IR, see "Front View" on page 5.
2 Verify that the batteries are properly installed.
3 If the batteries are old, install new batteries.
NOTE: Bright lights or other infrared devices may interfere with
your remote control and IR on the TV display.
W3207C_UM_EN.book Page 38 Friday, June 30, 2006 10:42 AM