Chassis intrusion switch, Removing the chassis intrusion switch – Dell Precision 650 User Manual
Page 10
Back to Contents Page
Chassis Intrusion Switch
Dell Precision™ Workstation 650 and Dell Precision Workstation 450 Service Manual
Removing the Chassis Intrusion Switch
Replacing the Chassis Intrusion Switch
Removing the Chassis Intrusion Switch
1.
Remove the front panel
.
2.
Disconnect the chassis-intrusion switch cable from the
I/O Panel
connector.
3.
Feed the chassis-intrusion switch cable through the routing holes in the drive door and the front of the computer.
4.
Slide the chassis intrusion switch up out of its slot.
5.
Lift both the chassis intrusion switch and the switch cable away from the computer.
Dell Precision 650 Computer
Dell Precision 450 Computer
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.
NOTICE:
Before disconnecting a device from the computer or removing a component from the system board, verify that the standby power light on the
system board has turned off. To locate this light on the Dell Precision 650 computer, see "
System Board Components
" or on the Dell Precision 450
computer, see "
System Board Components
."
NOTE:
On the Dell Precision 650, you must
open the drive door
to feed the chassis-intrusion switch cable through the routing holes.