Dell Precision 650 - Manual (Page 47)

Back to Contents Page
Drives — Dell Precision™ 650 Computer
Dell Precision™ Workstation 650 and Dell Precision Workstation 450 Service Manual
Overview
Hard Drive
Floppy Drive
CD/DVD Drive
Overview
Your computer supports:
l Three hard drives
l One floppy drive
l Three CD or DVD drives
IDE Drive Addressing
When you connect two IDE devices to a single IDE interface cable and configure them for the cable select setting, the device attached to the last connector on
the interface cable is the primary (master) or boot device (drive 0), and the device attached to the middle connector on the interface cable is the secondary
(slave) device (drive 1). See the drive documentation in your upgrade kit for information on configuring devices for the cable select setting.
Since cable select is the default setting, any additional drives that are installed do not need to be set as a primary or secondary drive.
Your computer supports up to two IDE devices. Hard drives should be connected to the connector labeled "IDE1," and CD/DVD drives should be connected to
the connector labeled "IDE2."
Connecting Drive Cables
When you install a drive, you connect two cables—a DC power cable and an interface cable—to the back of the drive.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.
1 floppy drive(s)
2 CD/DVD drive(s)
3 hard drive(s)