Chicago Electric 90 AMP FLUX WIRE WELDER 68887 - Manual (Page 10)

Page 10 For technical questions, please call 1-800-444-3353. Item 68887
WARNING
The following steps require applying power to the Welder
with the cover open.
To prevent serious injury from fire or electric shock:
1. Do not touch anything, especially not the Ground Clamp,
with the Gun or welding wire or an arc will be ignited.
2. Do not touch internal Welder components
while it is plugged in.
14. Do not touch the Gun’s Trigger.
Plug the Power Cord into its electrical
outlet and turn the Welder to ON.
15. Point the Gun away from all objects and press
the Trigger until the wire feeds out of the Gun
two inches.
The Wire Liner may come out with the welding
wire, this is normal, just push the Wire Liner
back into the Gun.
If the wire does not feed properly and the
Spool is stationary, turn the Welder to OFF,
unplug it, and slightly tighten the Feed
Tensioner clockwise before retrying.
ON MIN
OFF MAX
WIRE FEED SPEED
GUN
GROUND
120V~
60Hz
20A
90 AMP FLUX WIRE WELDER
ITEM 68887
Specifications
Wire 0.030" – 0.035" Flux-Core
Capacity 18 Ga. – 3/16" Steel Plate
Weldable
Materials
Mild, Low Alloy Steel
(Not for Aluminum or Stainless Steel)
Welding
Wire
Gun
2″
SAFETY
MAINTENANCE
BASIC WELDING
WELDING TIPS
SETUP