Canon BP-511 - Manual (Page 136)

136
REFERENCE
An incorrect battery pack is being used.
➡ Use Battery Pack BP-511. ( → 3)
Battery pack is not correctly attached to the compact power adapter.
➡ Attach the battery pack correctly. ( → 22)
The DC coupler is connected to the compact power adapter.
➡ Remove the DC coupler plug from the compact power adapter.
(
→ 23)
The battery pack is out of power.
➡ Charge the battery pack. ( → 22)
Battery pack is not inserted correctly.
➡ Insert the battery pack correctly. ( → 24)
Battery chamber cover is not closed.
➡ Close the battery chamber cover tightly. ( → 24)
CF card slot cover is not closed.
➡ Insert the CF card firmly until the CF card eject button pops out, then
close the CF card slot cover tightly. (
→ 28)
If the Main Switch is set to < OFF > immediately after taking a picture,
the access lamp continues flashing for a few seconds until the image is
stored on the CF card.
➡ After the image has been stored on the CF card the access lamp will
go out and the camera will turn off automatically.
Battery pack is not sufficiently charged.
➡ Charge the battery pack fully. ( → 22)
Battery pack is beyond its useful life.
➡ Obtain a new battery pack. ( → 138)
Auto power off function is operating.
➡ Switch the camera on again with the main switch, or turn off the Auto
power off function. (
→ 120)
Battery pack level is very low.
➡ Charge the battery pack. ( → 22)
Camera is not operating properly.
➡ Press the shutter button down halfway to reset the camera to
normal. (
→ 29)
∗
If the < > icon still appears, the camera needs repair. Take it to
a Canon Service Center. ( → back cover)
Troubleshooting
If you have a problem with your camera, first refer to this Troubleshooting Guide as you check
the camera.
Power
Unable to charge
battery pack.
Main switch does
not turn the camera
<ON>.
Access lamp blinks
even when the
Main Switch is
<OFF>.
Battery loses power
quickly
Camera switches
off by itself
Only the < > icon
blinks on the LCD
panel